Often, just the addition of a piece of trim creates outstanding binding. Wood bindings are available in colors for example, sometimes a very thin strip of red trim is used amongst black and white bindings. Laminated wood and plastic trims come in laminated combinations such as black/white/black (referred to as b/w/b). There are quite a number of decorative strip materials available to customize your bindings. If you install 0.120" binding in a slightly smaller channel, you can scrape away the excess and achieve in-between sizes. Because it's so wide, small variations in width produced by sanding and scraping aren't obvious (also true of 0.090" binding). The 0.090" width is another good choice when you want to overhang the fret crown onto the binding.Ġ.120" The width of 0.120" binding leaves a good safety margin for scraping and sanding. Also, 0.060" provides a good width when you want the fret crown to lay over the binding at the ends of the frets.Ġ.090" This is a fairly wide binding that's often used alone, as a single strip of white or cream (on Les Paul Customs, for example). It makes a good outer binding when adding purfling (for example, a black/white/black inlay inside the binding). If the binding sticks out over the edge of the instrument, it needs to be sanded or scraped flush, and this will show up as a thin spot in this already-thin binding.Ġ.060" The difference in width between 0.040" and 0.060" is substantial, and the 0.060" width is popular. It doesn't provide much width to work with, so the channel holding it must be very uniform and accurate. Plastic bindings are available in white, cream, or black in these widths:Ġ.040" This narrow binding is often found on older vintage guitars, banjos, and mandolins. Acetone (a common solvent used with plastic), and other solvents used in finishing are also flammable. Fire Hazard! Plastic bindings, along with their shavings and dust, are very flammable.Keep the work area well-ventilated to evacuate dust and solvents.Wear protective gloves when handling chemicals such as finishes.Wear eye protection when using tools, glues, and finishes.Hand tools, power tools, finishes and glues are all hazardous if misused. These instructions cover the basic techniques used to bind guitars and other stringed instruments. They can be clear-finished along with the wood, or kept free of colored finishes so they provide a visual contrast. They are sanded and smoothed to make them level with the surrounding wood. When bindings contain extra decorative strips that aren't exposed on the edges of the guitar, these strips are often called "purflings."īindings and purflings are installed during the building process, before a finish is put on the instrument. They can be plain or fancy: a simple white strip or an intricate decoration made of many laminated pieces ("herringbone" is a popular example). The plastic or wood bindings around an instrument add good looks and protect it from bumps and nicks on the edges. View All WOODSTAX - Shop Tonewood by the Piece.View All All Hardware + Parts by Instrument.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |